How to configure WebPRNT TSP650 via HTTP requests

Before you start

For the setup of the printer, we will need the test receipts.

To perform a hardware test on your printer, follow these 5 following steps.

1. Turn off the Star printer.

2. Press and hold the feed button.

3. Turn the printer back on.

4. Continue to hold the feed button until the Network Configuration report prints out. This will print out two test receipts. At the bottom of the second page, it will show Current IP Parameters Status. Keep this page or note down the IP Address.

5. Confirm the printer’s IP address.

In our example the IP address is 10.1.10.165. Please note that your IP address may be different.

 Important:

Your IP address will likely be different to the one listed in the picture above.

Setting up WebPRNT

Here you can take the following actions to set up the device successfully:

1. Open your web browser and type the Star printer’s IP address into the URL field

2. Log in to the Star Network Utility using these credentials
   User: root
   Password: public

3. Click on WebPRNT in the left side menu.
   The WebPRNT Service field should show ENABLE. If it doesn’t, please switch it to ENABLE and click submit.

4. Select Save in the left side menu and go to Configuration printing > Restart device, then click Execute.

The receipt printer should restart now and print a new configuration report.

Enable WebPRNT On POS

After successfully setting up the printer, we have to connect the printer to the POS.

1. Log into the POS, open the side menu on the left and click Settings

2. Click Printer and open tab Star WebPRNT Printer

3. Enable and fill out your printer’s IP address and port

1. Click the Check button at the bottom of the page. If the printer prints out a receipt that reads PWA POS test then the printer is successfully set up, you can use it.